36
Service Supplement
RX220
Replacing the SATA backplane
Replacement routines
4.8
Replacing the SATA backplane
Ê
Open the server as described in the
section “Preparation” on page 17
Ê
Disconnect the data cable of the CD/DVD drive. Carefully fold the cable to
the side.
Ê
Remove all the other cables from the SATA backplane.
Ê
Pull both hard disk modules out slightly.
Figure 23: Removing the SATA backplane
Ê
Loosen the knurled screw (see figure) from the SATA backplane, then move
the backplane to the direction of the arrow until its holes disengage from the
housing stand-offs.
Lift the SATA backplane, then set it aside.
Ê
Install the new SATA backplane, match its holes with the housing stand-offs
then move it to the opposite direction to lock.
I
Be careful of the hard disk connections and the lighting wires.
Ê
Fasten the knurled screw.
Ê
Connect all cables to the SATA backplane (see
Ê
Push both hard disk modules inward.
