70S_Rev1
4
Safety Information
WARNINGS!
Do not touch the splicer, AC power cord and AC plugs with wet hands. This may result
in electric shock.
Do not operate splicer near hot objects, in hot temperature environments, in dusty /
humid atmospheres or when water-condensation is present on the splicer. This may
result in electric shock, splicer malfunction or poor splicing performance.
When using optional battery, follow the instructions below.
Failure to follow these may result in explosion or personal injury.
• Do not charge battery with other methods than instructed.
• Do not discard battery into an incinerator or fire.
• Do not charge or discharge battery near a flame or under direct sunlight.
• Do not excessively shake or jar the battery.
• If battery leaks of liquid residue, be careful handling the battery so the liquid does
not get in skin or eye contact. If it reaches contact, immediately wash skin or eyes
thoroughly and see the doctor. Dispose of the battery and call the service center
for replacement.
• Do not stack battery on top of AC adapter while charging.
• If charge did not complete in five hours or the "CHARGE" LED does not turn ON,
immediately stop charging and call the service center for repair.
When transporting the carrying case using the shoulder belt, check the belt and hooks
for damage before use. Carrying the case with a damaged shoulder belt may cause
the belt to break or come off and result in personal injury or equipment damage.
CAUTIONS!
Do not store splicer in any area where temperature and humidity are extremely high.
Possible equipment failure may result.
Do not touch protection sleeve or tube-heater during heating or immediately after
completion of heating. Their surfaces are very hot and touching these may result in
skin burn.
Do not place the splicer in an unstable or unbalanced position. The splicer may shift
or lose balance, causing the unit to fall. Possible personal injury or equipment
damage may result.
The splicer is precision adjusted and aligned. Do not allow the unit to receive a strong
shock or impact. Possible equipment failure may result. Use supplied carrying case
for transportation and storage. The carrying case protects the splicer from damage,
moisture, vibration and shock during storage and transportation.
