FujiFilm X-A7, Owner'S Manual

Page: 232 / 258

214
T
echnical Not
es
12
•
Do not use the device in locations subject to magnetic fi elds, static electricity, or radio interference. Do not use the device in locations subject to magnetic fi elds, static electricity, or radio interference.
Do not use
the transmitter in the vicinity of microwave ovens or in other locations subject to magnetic fi elds, static
electricity, or radio interference that may prevent reception of wireless signals. Mutual interference may
occur when the transmitter is used in the vicinity of other wireless devices operating in the 2.4 GHz band.
•
The wireless transmitter operates in the 2.4 GHz band using DSSS, OFDM and GFSK modulation. The wireless transmitter operates in the 2.4 GHz band using DSSS, OFDM and GFSK modulation.
•
Security : Wireless network and Bluetooth devices transmit data via radio and consequently their use re-
quires greater attention to security than applies in the case of wired networks.
-
Do not connect to unknown networks or networks to which you do not have access rights, even if
they are displayed on your device, as such access may be considered unauthorized. Connect only to
networks to which you have access rights.
-
Be aware that wireless transmissions may be vulnerable to interception by third parties.
•
The following may be punishable by law: The following may be punishable by law:
-
Disassembly or modifi cation or this device
-
Removal of device certifi cation labels
•
This device operates on the same frequency as commercial, educational, and medical devices and wireless trans- This device operates on the same frequency as commercial, educational, and medical devices and wireless trans-
mitters.
mitters.
It also operates on the same frequency as licensed transmitters and special unlicensed low-volt-
age transmitters used in RFID tracking systems for assembly lines and in other similar applications.
•
To prevent interference with the above devices, observe the following precautions. To prevent interference with the above devices, observe the following precautions. Confi rm that the RFID trans-
mitter is not in operation before using this device. Should you observe that the device causes interfer-
ence in licensed transmitters used for RFID tracking, immediately stop using the aff ected frequency or
move the device to another location. If you notice that this device causes interference in low-voltage
RFID tracing systems, contact a Fujifi lm representative.
•
Do not use this device on board an aircraft. Do not use this device on board an aircraft. Note that Bluetooth may remain on even when the camera
is off . Bluetooth can be disabled by selecting OFF for D CONNECTION SETTING > Bluetooth
SETTINGS > Bluetooth ON/OFF .
•
Maximum radio-frequency power (EIRP): Maximum radio-frequency power (EIRP):
WLAN 2.4 GHz: 9.33 dBm
Bluetooth: 8.13 dBm