FujiFilm DR-ID 670, Operation Manual

Page: 7 / 62

1-1
For Safe Operation
1
DR-ID 670 Operation Manual 897N102735
Chapter 1
For Safe Operation
1.1 Safety
Before using the DR-ID 670, read this section thoroughly to ensure that you use the product properly.
Electric Shock Warnings and Cautions
WARNING
The power supply to the DR-ID 670 is AC100 to 240V.
To avoid electric shocks, users should always take the following precautions:
● Never open any covers of the equipment.
● Install the equipment in a location where it will not be exposed to water.
● Check that the equipment is securely earthed.
● Check that all of the cords and cables are completely and securely connected.
WARNING
Do not touch the patient’s body while touching the control cabinet. Otherwise, the patient may
receive an electric shock.
WARNING
Do not use a multiple tap connector or extension cable for powering the devices constituting
the system. Otherwise, fire or electric shock may occur due to the electrical load exceeding the
allowable limit.
WARNING
Observe the following precautions when using the cables.
● Turn off each unit before connecting/disconnecting the cable.
Do not touch the plug and connector with wet hands. Otherwise, electric shock may result,
causing death or severe injury.
● Hold the plug or connector when removing the cable.
Pulling the cable or carrying by holding it may damage the cable, causing fire or electric shock.
● Do not damage or remodel the cable.
Do not place a heavy object on the cable or lay it under the flat panel sensor. Do not step on,
pull, forcibly bend, or bundle the cable. Otherwise, fire or electric shock may result.
● Do not use the flat panel sensor for the radiographic examination stand if its cable becomes
overloaded. Otherwise, the cable may be damaged, causing fire or electric shock.
WARNING
Do not turn on the system with dew condensation on the flat panel sensor. Otherwise, fire or
electric shock may result.