Fujicom PDP TV, User Manual

Page: 10 / 18

8 9
Application instruction of remote control
In order to receive TV program, signal should be
received from one of the following signal sources:
Outdoor antenna.
Cable TV network.
Satellite broadcast network
1.In these three cases, the input cable of antenna or TV
network should be plugged in the 75 Ohm coaxial
cable jack at the rear side of PDP TV.
2.
When installing PDP TV , 75 Ohm coaxial Cable
must be used. If other coaxial cable is used, there may
be noise and image disturbances.
Indoor antenna is NOT recommended for this TV
quality
In order to receive digital TV programs, a digital TV STB
must be connected to the rear of the PDP TV.
Connect the coaxial cable connector to
The output terminal.
The antenna input terminal.
For further instruction refer to the receiver instruction
manual
Connecting digital TV Set Top Box
Connecting to antenna or TV radio network
Cable TV network
Or
The rear of TV
RF(75 )
The of TV
must be used
Video
Audio
L R
Digital TV receiver
RF(75 )
POWER: Power on/off button , press once to turn the TV on and press again to turn the TV off.
SLEEP: Sleep button , setting TV power off time.
MUTE: Mute button , press once to disable the audio and press again to enable the audio.
0,1-9: TV channel selection button.
-/--: TV channel range selection button, select TV channel by entering 1,2 or 3 digits.
: Previous channel button , return to the previous channel watched.
SOURCE: Signal source selection button (TV/AV/SVIDEO/YPBPR/PC/HDMI).
P.STD: P.STD button , setting the picture mode for TV/AV/SVIDEO/YPBPR/PC/HDMI input mode.
S.STD: S.STD button , setting the sound mode.
DISPLAY: Press display button to view the current channel. Press again to remove channel information.
MENU: OSD menu button , to enter the TV setup menu.
/ (UP/Down): Up and down button of OSD menu. To change the OSD menu items and to increase or
decrease the channel.
/ ( Left/Right): Left and right button of the OSD menu. To select the OSD menu items and to increase or
decrease the volume.
VOL+/-: Volume adjusting button, to increase or decrease the volume.
/-: Channel selection button, to increase or decrease channel.
I/II: NICAM function button, to select the sound mode