INP-TN5A1634-E
7
5
Connecting your PC to the module-type temperature controller
Connect your PC to the module-type temperature controller using the RS-232C interface.
Note
•
Make the setting, being careful not to make the station Nos. of the module-type temperature controllers duplicate. The station
number of the control module (PUMA/B) or the analog module is the station number configuration 1, and that of the event
module (PUME) is the station number configuration 17.
•
Connection via RS-485 communication is not supported.
•
When operating the parameters of the enhanced communication module, connect the loader connecting cable to the loader
communication port of the enhanced communication module.
•
Connection with RS-232C
Provide the optionally available cable for loader connection (RS-232C, Type: PUMZ *L01). Connect the RS-232C port (D-sub 9
pin) and the loader communication port on the front face of the module-type temperature controller with the loader connecting
cable.
[When connecting the PUM parameter loader to a control module, an event module, and an
analog module]
<Connecting a single unit>
LOADER
PUM-A
PWR
COM
OUT1
OUT2
OUT3
OUT4
STATION
4
3
2
1
0
F
E D C B
A
9
8
7
6
5
D-Sub 9 pin
PC
Master
Loader connecting cable
(RS-232C)
PUMZ*L01
RS-232C
Station number
configuration switch
