2-6
To comply with EMC Directives
Use an EMC filter built-in inverter.
All the connecting cables and wires must be
shielded. As shown in Figure 2.9, remove outer
sheath of the cable to bare the shield layer for
clamping. Ground the shield onto the EMC flange
for EMC compliance using clamps provided.
Figure 2.9 Shielded Wire Connection to Comply
with EMC Directives
Figure 2.10 Grounding Shields to Comply with EMC Directives
For EMC directives, refer to the FRENIC-Mini Instruction Manual (INR-SI47-0791-E),
Chapter 11 "COMPLIANCE WITH STANDARDS."
Length L differs according to the
inverter type. Keep it as short as
possible.
Remove the sheath here.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]