Manual_FCS-C1000_V1.1_EN
16
5F
5H
STEP 6:
Use the M4 (7mm) sleeve to unscrew the nut and then connect the grounding cable (6A-6C). Use
another sleeve to fix the nut in the opposite, and then at the same time tight the grounding cable nut.
Note: After the fuel cell stack is finished using, disconnect the grounding cable.
Connect the stack to the purge valve through the filter for a longer running time and a better
performance (6D-6F). If not, the gas out of stack may have a negative effect on the purge valve
after a long time running. Connect the output of the purge valve to a place away from the stack in
case of the damage caused by the hydrogen leakage.
6A
6B
6C
6D
Summary of Contents for H-1000
