PAG.37
rev 1.2
OSD 79
OSD 80
OSD 81
need to use the new password to open locked menus or locked
channels.
NOTE: The default password is 0000
5. Press [Exit] to leave the “Parental Lock” menu.
5.6. POWER SETTING
When you select this option, you will see a screen like beside
(OSD 79):
1. LNB Power: If your receiver is connected to the LNB direct-
ly then you need to set the LNB Power to “On”. If your receiver
is connected to a multi switch (SMATV signal distribution sys-
tem) then it may be that you don’t need to provide the power
to the LNB. But since this is depending on the kind of installed
distribution system we recommend you to contact your install-
er or to refer to the user manual of this system to get the cor-
rect information.
You also just can change this setting and check if you still can
receive the channels. If the LNB Power is off and you still can
see all channels then we recommend this setting.
2. Low Power Consumption: At this option, you could enable
/ disable the low power consumption mode. This mode allows
saving current consumption when the receiver is stand-by.
Low power consumption mode only can be enabled when the
VCR Loopthrought option (see point 5.2.) is STB master select-
ed. By the other way, if you choose VCR master, then the Low
Power Consumption option will not be active and the receiver
will not be in LPC mode.
3. Press [Exit] button to leave this menu.
5.7. RCU POSITION SWITCH
In order to avoid interferences between remote controls, you
have the possibility to change the code of it, to do that you have
to change the position of a switch in the remote control.
But fi rst of all you have to change this code in the receiver. You
can do this in the menu “RCU Position” (OSD 80).
You have to select the same position in the receiver than in the
remote control (OSD 81).
SYSTEM SETUP
ENGLISH
Summary of Contents for MAX S402PVR
Page 1: ...MAX S402PVR...
