Section 6
Parameter Settings
49
FT702LT Flat Front Wind Sensor Manual
6.4.16 RS: Reset the FT702LT
Command
Parameter
RS
Command
Syntax
SET Sensor:
$<listenerID>,RS<mode>*<checksum><cr><lf>
$aa,RSc*hh<cr><lf>
QUERY Sensor:
NA
FT702LT output:
None
Parameters
<mode>
F
reset the FT702LT, loading the factory default settings
S
reset the FT702LT, loading saved parameters settings only available
from build version 22 and above
U
reset the FT702LT, reloading the user parameter settings
Examples
Example 1
Reset the FT702LT, reloading the last parameter settings
Message
Comment
$01,RSU*//<cr><lf>
Reset sensor, reloading last settings
Description
Use the RS command to reset the FT702LT software. The sensor will be ready to receive
new commands or take readings from a maximum of 2 seconds after any reset command is
sent.
To restart the software, but continue to use the previous user parameter settings use the
RSU command
To restart the software, but load the saved parameter settings use the RSS command,
(RSS command only available from build versions 22 and above)
To restart the software, but load the factory default parameter settings use the RSF
command
From build version 22 and above the user parameters can be saved or backed up into the
flash memory of the sensor. See command US (Section 6.4.24) for a description for setting
or querying these Saved Parameters.
