Frontier SB1388, Operator'S Manual

Page: 29 / 60

ASSEMBLY
OM 0437SB1388-A
27
NOTE: Before
cutting, make sure the two shafts
intersect by at least 5" when in working position that is
when the snowblower rests on the ground.
3.
Hold the two half-shaft side by side and locate the
"L"
length between the two center-to-center half-
shaft universal joints. Mark off the zone to be cut
on both halves opposite each half-shaft guard as
shown on figure 21
4.
Cut off inner and outer guard tubes as well as the
inner and outer telescopic sections.
5.
Cut the guard a second time leaving the same
distance between the end of the guard and the
end of the shaft as existed before. To obtain the
proper distance "A" shown on figure 22, cut the
guard according to the following table:
DISTANCE A
Male PTO Female PTO
1 3/4" 1 1/4"
3.
File down tubes and remove chips.
4.
Apply grease to inside of outer telescopic section.
IMPORTANT: Work with fully guarded shafts
only!
Figure 21
Figure 22
A