Fronius TransSteel 3500 Syn, Operating Instructions Manual

Page: 76 / 144

EasyJob mode
General The "Save" buttons allow up to 5 EasyJob operating points to be saved. Every op-
erating point matches the settings on the control panel.
EasyJobs can be stored for each welding process.
IMPORTANT! Setup parameters are not saved at this time.
Storing EasyJob
operating points
1
Press and hold one of the "Save" buttons to save the current set-
tings on the control panel, e.g.:
- The left indicator displays "Pro"
- After a short time, the left indicator switches to the original
value
2
Release the "Save" button
Retrieving Easy-
Job operating
points
1
To retrieve saved settings, press the corresponding "Save" button
briefly, e.g.:
-
The control panel will show the saved settings
Deleting Easy-
Job operating
points
1
Press and hold the relevant "Save" button to delete the memory
content of that "Save" button, e.g.:
- The left indicator displays "Pro".
- After a short time, the left indicator switches to the original
value
2
Keep the "Save" button held down
- The left display shows "CLr".
- After a while, both displays show "---"
3
Release the "Save" button
Retrieving Easy-
Job operating
points on the Up/
Down welding
torch
One of the "Save" buttons on the control panel must be pressed in order to re-
trieve the saved settings using the Up/Down welding torch.
1
Press one of the "Save" buttons on the control panel, e.g.:
The control panel will show the saved settings.
The "Save" buttons can now be selected using the buttons on the Up/Down weld-
ing torch. Vacant "Save" buttons are skipped.
76