Fronius TransSteel 3500 Syn, Operating Instructions Manual, Page: 45 / 144

TSt 5000 MV
Syn 3 x 208 / 230 / 400 / 460
V AWG 6 *) 4G10
*) Canada / US cable type: Extra-hard usage
The item numbers of the different cables can be found in the Spare Parts List of
the device.
AWG ... A merican W ire G auge
Connecting the
mains cable If no mains cable is connected, a mains cable that is suitable for the connection
voltage must be fitted before commissioning.
The ground conductor should be approx. 10 - 15 mm (0.4 - 0.6 in.) longer than
the phase conductors.
An illustration of the mains cable connection can be found in the following sec-
tions: "Fitting the strain-relief device" or "Fitting the strain-relief device for
Canada / US". To connect the mains cable, proceed as follows:
1
Remove the side panel from the device
2
Push the mains cable in far enough to make it possible to connect the ground
conductor and the phase conductors to the block terminal properly.
3
Fit ferrules to the ground conductor and phase conductors
4
Connect the ground conductor and phase conductors to the block terminal
5
Use the strain-relief device to secure the mains cable
6
Fit the side panel of the device
Fitting the
Europe strain-
relief device
3
1
2
5
4
7
1
3
4
10
0mm
(4
in
ch
)
PE
2
2
45
EN