Fronius TransSteel 2200, Operating Instructions Manual

Page: 58 / 136

Fdi
1
2 3 4 5 2,5 1
t (s)
(m/min, ipm)
Wire threading process (press the
"Wire threading" button on the control
panel):
- Hold down the button for up to one
second (briefly press the button): the
wire speed stays at 1 m/min (39.37
ipm) for the first second
- Hold down the button for up to 2.5
seconds : after one second, the wire
speed increases over the next 1.5
seconds.
- Hold down the button for longer than
2.5 seconds : after 2.5 seconds, the
wire is fed at a constant rate equal to
the wire speed set for the Fdi welding
parameter.
Selecting the
desired country-
specific setting - The country-specific setting of the power source defines the unit (cm + mm or inch)
in which the set welding parameters are displayed
- The country-specific setting can be changed in the Setup menu 2nd level (Para-
meter SEt)
•
A description of the SEt parameter and how to adjust the SEt parameter can be
found in section
Setup Menu 2nd Level from page 100
Connecting the
gas cylinder
WARNING!
Danger from gas cylinders falling over.
Serious personal injury and damage to property may result.
▶
Place the gas cylinders on a level and stable surface.
▶
Secure the gas cylinders to prevent them from falling over
▶
Observe the safety rules of the gas cylinder manufacturer.
1 2
58