Fronius TransSteel 2200, Operating Instructions Manual, Page: 120 / 136

no | IGn
"Ignition time-out" function is active; current did not start flowing before the
length of wire specified in the Setup menu had been fed. The power source
safety cut-out has tripped
Shorten the wire stick-out; press the torch trigger again; clean the surface of
the workpiece; if necessary, set the "Ito" parameter in the Setup menu Cause:
Remedy:
no | ARC
Arc break during TIG welding
Press the torch trigger repeatedly, clean the surface of the workpiece Cause:
Remedy:
EPG | 17
The selected welding program is invalid
Select a valid welding program Cause:
Remedy:
EPG | 35
Measurement of the welding circuit resistance failed
Check grounding cable, current cable, or hosepack and replace if neces-
sary, re-measure the welding circuit resistance Cause:
Remedy:
120