Creating Reference Program
Safety
WARNING!
Work performed incorrectly can cause serious injury and damage to property.
▶
This setting work must only be carried out by trained and qualified personnel.
▶
Observe the safety rules in the OI, in particular the "Safety Inspection" section.
General
A pilot laser with low power is required for the described adjustment work.
A reference program will also need to be created:
-
After the laser welding head is installed for the first time
-
When programming a new part, if the x-, y- and z-values have changed on the
adjustment units.
Creating a Refer-
ence Program
The scope of supply for the laser welding head includes a metal gauge for the exact
adjustment of the wire electrode position with respect to the laser focus.
This gauge is mounted in the working area of the robot and is used to create a reference
program for the series components.
Create a reference program before welding the first series component
Requirement:
-
The laser welding head must be set up and fully connected.
-
The wire electrode must be threaded in.
-
With the wire electrode, the stick out must be adjusted for the relevant application
-
Observe the focal width specification on the laser optics
1
Mount gauge (1) in the working area of the robot
2
Switch on pilot laser
3
Position laser welding head via robot so that the pilot laser beam hits the gauge at
an angle of 90°
77
EN-US
Summary of Contents for LaserHybrid SB 360i
