14
Stopping the
„flash operation“
CAUTION!
Risk of sparks when disconnecting the charging terminals. Before
disconnecting the charging terminals, stop the „flash operation“ by pressing the
Start/Stop button.
Boost mode
If the battery voltage drops while power is being supplied externally because more power
is needed (e.g. because additional consumer loads are switched on), the device goes
into boost mode.
1.
Stop the „flash operation“
3.
Disconnect (-) charging terminal from battery
4.
Disconnect (+) charging terminal from battery
5.
2.
Ensure charging terminals are connected to correct poles
3.
Start the „flash operation“
Starting the
„flash operation“
manually
(continued)
2.
Press the Info button to display the parameters in the following sequence:
- actual charging current
- actual battery voltage
- amount of charge (Ah) fed in so far
- energy (Wh) fed in so far
- length of time charging so far
Important! To maintain the battery voltage at a constant level, the charger can increase
the current in boost mode to the maximum charging current (see Technical Data).
To prevent the device overheating, the max. output current can be automatically limited if
the ambient temperature rises to above 35°C/95°F (power derating).
If there is no confirmation of correct pole connection within 2.5 secs, the device reverts
to menu mode.
Summary of Contents for Acctiva Professional 30A UCN
Page 2: ......
Page 12: ...IV ud_fr_ls_sv_01086 042006...
Page 52: ...IV ud_fr_ls_sv_01087 032006...