Fronius 8,045,368, Operating Instructions Manual

Page: 40 / 60

38
Path welding
1. Set the "Start LEFT / STOP / Start RIGHT" toggle switch to the "STOP" (0) position.
2. Press the "SELECT / ENTER" button for 3 seconds to enable parameter entry.
Every time you access the set-up menu, the "welding segment" parameter is auto -
matically displayed.
Press the "SELECT / ENTER" button again and select "Pause segment".
3 sec.
Path welding allows a defined path to be welded permanently. For this it is necessary to
set the total path. The welding process stops automatically once this programmed total
path has been travelled.
The following parameters must be set for path welding:
- Duration of crater filling [s]
- Duration of back-filling [s]
- Total path [cm]
Enter the parameters as follows:
3. Press the "+ / -" repeatedly until "Con" appears in the display.
Press the "SELECT / ENTER" button to accept the setting. The next parameter is
selected:
4. Press the "+ / -" buttons and set the desired end-crater time (e.g. "2.5 s").
Press the "SELECT / ENTER" button to accept the value. The next parameter is
selected.