Fronius 8,045,368, Operating Instructions Manual

Page: 38 / 60

36
8. Turn the "Welding ON/OFF" toggle switch to the "ON" position.
9. Turn the "Start LEFT / STOP / Start RIGHT" toggle switch to the desired setting and
start interval welding. To stop the process early, turn the switch to the "STOP" (0)
position.
IMPORTANT! Interval welding stops automatically once the preset total path has
been travelled or when the relevant limit switch on the driving vehicle is actuated.
6. Press the "+ / -" buttons and set the desired back-fill time (e.g. "1.0 s").
Press the "SELECT / ENTER" button to accept the value. The next parameter is
selected.
Interval
welding
(continued)
5. Press the "+ / -" buttons and set the desired end-crater time (e.g. "2.5 s").
Press the "SELECT / ENTER" button to accept the value. The next parameter is
selected.
7. Press the "+ / -" buttons and set the desired total path (e.g. "100 cm").
If no total path is required, keep the "InF" setting.
Press the "SELECT / ENTER" button to accept the value. Parameter entry is deacti -
vated and the current traversing speed of the driving vehicle is displayed (e.g. "60.0
cm/min").