Fronius 8,045,368, Operating Instructions Manual

Page: 32 / 60

30
Mounting and
adjusting the
welding torch
(continued)
Driving vehicle
strain relief
(b)
3. Adjust the torch angle:
- Undo the fastening screws (a)
- Turn the clamp block (b) and
set the desired angle
- Fix the locking lever (a)
4. Turn the adjusting wheel on the
relevant mechanical adjustment unit
(c), (d) until the correct welding torch
position is reached.
Setting up the welding torch
(d)
(c)
(a)
To attain optimum wirefeed, observe the following when laying the hose pack:
- Do not allow the hose pack to become kinked
- Always lay the hose pack as straight as possible
- Suspend the hose pack (it must not come into contact with the floor), use balancers
and hose pack holders (e.g. Universal hose pack holder)
Hose pack handling
1. Undo the fastening screw (a) on the
clamp
2. Insert the hose pack as illustrated
IMPORTANT! Make sure the hose
pack does not become kinked - this
can lead to wire feed problems.
3. Tighten the fastening screw (a)
Fixing the hose pack
(a)
IMPORTANT! Please note the
maximum tension load on the
hosepack holder (see chapter
„Technical Data“). This must not
be exceeded.