II
The device is to be used exclusively for its intended purpose.
Utilisation for any other purpose, or in any other manner, shall be deemed to
be „not in accordance with the intended purpose“. The manufacturer shall
not be liable for any damage resulting from such improper use.
Utilisation in accordance with the „intended purpose“ also comprises
-
that the device is undamaged and in perfect condition
-
carefully reading and obeying all the instructions in these operating
instructions, especially the safety rules and all safety and danger notices
-
setting up and installing according to the operating instructions
-
performing all stipulated inspection and servicing work
-
observing all advice from the manufacturer regarding gas supply com-
ponents
-
observing all advice from the battery manufacturer
-
obeying other relevant national safety rules
The device may not be used if any part has been submerged in or flooded
with water. Notify the manufacturer or his representative immediately so that
the device can be checked and any affected parts replaced.
Utilisation in
accordance with
„intended purpo-
se“
All safety and danger notices on the device
-
must be kept in a legible state
-
must not be damaged/marked
-
must not be removed
-
must not be covered, pasted or painted over.
For the location of the safety and danger notices on the device, refer to the
section headed „General remarks“ in the operating instructions for the
device.
Before switching on the device, remove any faults that could compromise
safety.
Your personal safety is at stake!
General remarks
(continued)
CAUTION!
Operating the device in frost or wet conditions can
result in damage. The device may only be used in a frost-free, dry
environment.
Safety measures
at the installation
location
When installing devices with openings for cooling air, ensure that the cooling air can
enter and exit unhindered through the air ducts. Only operate the device in accordance
with the degree of protection shown on the rating plate. Refer to the „Setup regulations“
chapter in the device operating instructions