9
P323mane.fm
Removing the empty battery
If the red LED starts lighting while a tensioning or welding procedure, the capacity of the battery is exhausted.
All electric functions of the tool are blocked.
The seal efficiency is insufficient.
Warning! Straps with insufficient seal strength must be removed from the package!
The battery must be recharged.
Push the unlatching push buttons at both sides of the battery.
Push the battery out of the tool in the opposite direction of insertion.
When removing the battery the LED lights shortly red.
5.2
Adjustments
5.2.1 Preselecting of strap tension and tensioning speed
Do not adjust the tensioning force too high.
If the tensioning force is higher than the tensioning strength of the strap,
the strap will tear while the tensioning.
Tensioning force and tensioning speed can be preselected
with the right adjusting knob.
Turning clockwise increases;
turning counterclockwise decreases the tensioning force
and the tensioning speed resp..
The tensioning force on the minimum setting is 650 N
(146.25 lbs) and it is increased on the maximum setting to
3000 N (675 lbs).
The tensioning speed on the minimum setting is 152 mm/s
(6 inch/sec), it is increased on the middle setting to 225
mm/s (8.9 inch/sec) and remains on this value till the
maximum setting.
5.2.2 Adjusting the welding time
Depending on the size and quality of the strap, different
welding times are required.
The welding time can be adjusted at the left adjusting
knob.
Turning clockwise increases,
turning counterclockwise decreases the welding time.
5.3
Feeding the strap around the
package
The strapping is fed around the package as
illustrated.
Warning! The plastic strap which will be welded
must be free from oil, grease and other dirt.
Dirty plastic straps can't be welded correct!
Adjusting knob
Adjusting knob tensioning force /
tensioning speed
welding time
WWW.TRADITIONALTOOL.COM
For Parts & Service 1-877-862-6699
