11
P323mane.fm
5.6
Sealing of the joint
Press sealing lever down and let it go immediately.
The plastic strap is welded and cut off from the rest
of the strap.
During the welding the LED lights green.
After elapsing of the adjusted welding time (see
5.2.2) the cooling time begins (LED lights yellow).
During that time the tool must not be removed from
the strap.
If the LED lights green again, the sealing cycle is
finished.
The tool must not be removed from the strap as long as the cooling time is not
finished. Disregard of this regulation is causing insufficient seal efficiencies, which
can cause severe injuries.
5.7
Removing the tool
Pull up the handle lever,
pull the tool right / backwards and off the strapping.
5.8
Seal - Control
A regular control of the seal is necessary. The seal can be examined visually.
Make a seal, peel it apart and examine it as follows:
Correct seal
The seal must be completely welded over the whole width of the strap
on a length of ca. 19 mm. Minor quantities of fused plastic may
overflow on sides.
Welding time too short
The plastic strap is not welded over the whole width of the strap. The
seal efficiency is insufficient.
Warning! Straps with insufficient seal strength must be removed from
the package! Adjust the welding time (see 5.2.2).
Welding time too long
If the welding time is too long the straps are overheated. The fused
plastic overflows on both sides of the straps. The seal efficiency is
affected.
Warning! Straps with insufficient seal strength must be removed from
the package! Adjust the welding time (see 5.2.2).
WWW.TRADITIONALTOOL.COM
For Parts & Service 1-877-862-6699
