FS3.2780-Manual-34.111XXXXXXXXX.V01-EN03.doc
For further updates, see our website www.fromm-stretch.com and Login!
It is forbidden t
o duplicate this manual or parts thereof or any other form without the author’s authorisation © 2018
40
BASIC OPERATING INSTRUCTIONS
Programming of cycle
Upon machine start-up, the version of the software in the boards will be
displayed for the first 5 seconds.
Immediately afterwards the page will be displayed in automatic mode.
As it is the first
“P” Program
to be saved, keep
P:01
.
Now,
for example
, enter one of the 11 available
Special Functions
in the
first position (remember that a maximum of 4 functions can be used per
program).
Press the
“F” Special Function
key and you will see the first empty position
start flashing; press the
“+” key until you reach the first Function, which is the
“Overlap at pallet top” Function. Enter the function with the
“V” Value
key
and if you want to modify the value use the “+” or “-“ keys and confirm. (With
several values to be modified, always use the “V” key to switch from one
parameter to another.)
Press the
“F”
key again to enter a second special function. (Each time you
press “+” or “-“ to scroll the functions, the first option to be displayed is the
empty function.)
Continue by following the same steps as above.
The Program has now been saved.
If you wish, the various Function values (Top-press, Top-sheet, Single or
double wrapping, Film cut) and Keys (Pre-stretch, Carriage speed, Carriage
stretch, Top and Bottom Wrapping, Turntable speed) can be modified.
Press “Start” to start the wrapping cycle.
At the end of the cycle, the metres of film used can be seen in the program.
To save another program simply press “P” that will start flashing (starting, for
example, from the P:01 program or any other that has been programmed)
and with the “+” or “-“ keys to reach a new program (e.g. P:13). Save with
the “confirm” key or wait two seconds.
…
Program
direct selection
Press one of the keys from 1 to 9 in automatic mode and the machine
immediately starts the relative program, as if the program has been selected
and start has been pressed.
The 1..X key refers to two-digit programs (from 10 to 30).