Fromm FS390 Series, Original Manual, Page: 27 / 44

FS3.2780-Manual-34.111XXXXXXXXX.V01-EN03.doc
For further updates, see our website www.fromm-stretch.com and Login!
It is forbidden to duplicate this man
ual or parts thereof or any other form without the author’s authorisation © 2018
27
CONTROL PANEL
INDICATIONS
CYCLE ACTIVE, START ASCENT
An acoustic signal device has been installed in the electrical
panel. It activates before cycle start and lasts a few seconds as a
warning each time the automatic program is run. The operator
will therefore be able to exit the danger zone before the machine
starts operation.
The machine will start operating only after this period has
elapsed.
MACHINE ALARMS / RESET
If the emergency stop or any other safety device is triggered, the
wrapping machine’s automatic program will stop; this can be
ascertained also on the control panel’s display. Wrapping can
resume only after having removed the cause of the error and
pressed the Reset button on the electrical cabinet. By doing this,
the “fault” is reset and power is restored, obviously assuming that
the emergency button has been released or that the cause of the
“fault” that triggered the Error has been solved.
The turntable and the carriage return to the machine’s zero
position.
FS390 Control panel
A = multi-function display.
B = Program.
C = Special Function.
D = Value.
E = Top-press function.
F = Pre-stretch key.
G = Carriage speed key.
H = Stretch key.
I = Top and bottom wrapping
key.
L = turntable speed key.
M = Top-sheet function.
N = Single wrapping and double
wrapping function.
O = film cutting function.
P = manual keys.
Q =Automatic / Manual
selection key.
R = Saved cycles start-up
keys.
S = confirmation key of indication
highlighted on display.
T = Stop key.
U = Start key.
V = Reset key, starts the machine
at zero point.
Z = information key.
X = press and to
Increase or decrease the
indication highlighted on the
display.
ERRORS
E1
: Inverter error
E2 : Film finished or broken
E3 : Emergency stop
E4 : Door open
E5 : Protection sensors
E6 : No pallet detected
E7 : Turntable safety
E8 : Belt safety
WARNING
Contact maintenance
L
I
H
F
G
E
D
C
B
A X Z V
U
T
S
R
P
Q
M N O