12
A383 microlock man
11.3 Cleaning
If impact of dirt and dust is considerable and if painted straps are used the feed wheel must be cleaned
regularly. Normally it is sufficient to blow out this part by using an air gun.
11.4 Lubrication
The gear is filled with MOLYKOTE BR 2 PLUS. Use the same type of grease after repairs.
When being exchanged, all valve parts and other movable parts have to be greased with grease of type
Mobilux EP2 or with any equivalent product.
12 EXCHANGE OF WEARING PARTS
12.1 Exchange of punch and die halves
If in spite of a correct adjustment of the adjusting screw it is no longer possible to make a proper seal (see
seal control) the base plate must be removed and the wear of the punch and the die halves must be
examined.
If the cutting edges are destroyed or worn heavily (attention! the cutting edges of new punches and dies are
also rounded slightly) the corresponding parts must be replaced.
Important!
Make sure that the mounting surfaces are completely free from dirt before the new parts are installed.
After assembling the base plate, the base plate screws must be tightened using a torque wrench with
a torque of 90 Nm.
The screws N1.1323 and N1.1806 have to be secured with Loctite 222.
N1.1806
N1.1323
N1.1174
For Parts & Service 1-877-862-6699
WWW.TRADITIONALTOOL.COM
