10
A383 microlock man
10 SEAL ADJUSTMENT
The depth of the sealing mechanism and the cutter can be steplessly adjusted by turning the adjusting screw
with a screw driver.
Sealing depth is excessive
Turn adjusting screw clockwise.
A turn of 90
°
equals a stroke
correction of 0.25 mm/.010".
Sealing depth is
insufficient
Turn adjusting screw counter-
clockwise. A turn of 90
°
equals a
stroke correction of 0.25 mm/.010".
If low gauge and soft straps are used
the sealless joint is not always properly
formed (the straps do not interlock
properly). In order to avoid inproper
interlocking the timing of the interlock
can be influenced by the adjustment of
a throttle on the control valve body.
Under normal conditions the holding air
throttle is screwed flush into the outside
of the control valve body. If the straps
do not interlock properly (one or two
notches do not interlock at all) the
throttle has to be turned in a
clockwise direction.
Attention!
Adjust holding air throttle in such a way
that no tension marks on the
bottom of the seal caused by the punch
will be noticed. If marks are noticed the
punch might wear
prematurely.
For Parts & Service 1-877-862-6699
WWW.TRADITIONALTOOL.COM
