Boiler Installation
Boiler Assembly
Froling GmbH, Industriestrasse 12, A-4710 Grieskirchen, Austria
Page 21
www.froling.com
M1060008_US
3
3.4.1
Fitting doors on the left
Remove hinge pin clips by using two
small screw drivers to pry open the
wings of the clips
Detach the doors
Unscrew the hinge and back plate,
swap them over and reattach.
Rotate the pre-heating chamber
door and the combustion chamber
door and attach them on the left
hand side.
Additional steps for the fuel loading
chamber door:
Remove the gasket then remove the
radiating plate.
Detach the insulating plate from the
ceramic fiber gasket
Carefully lift out the insulating plate
Turn the insulating plate by 180°
and position it so that it lines up
with the holes provided
Re-install the radiation plate
Fix the gasket in place using gasket
cement
To re-mount the door, perform
removal procedure in reverse
