8
30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with Sealed Top Burners)
Care, Cleaning and Maintenance
Refer to the Owner's Guide for cleaning instructions.
If removing the range is necessary for cleaning or
maintenance, shut off gas supply. Disconnect the gas
and electrical supply. If the gas or electrical supply is
inaccessible, lift the unit slightly at the front and pull out
away from the wall. Pull only as far as necessary to
disconnect the gas and electrical supply. Finish removing
the unit for servicing and cleaning. Reinstall in reverse
order making sure to level the range and check gas
connections for leaks. See below for proper anchoring
instructions.
Anti-Tip Brackets Installation
Instructions
Important Safety Warning
To reduce the risk of tipping of the range, the range
must be secured to the floor by properly installed anti-tip
brackets and screws packed with the range. Failure to
install the anti-tip brackets will allow the range to tip
over if excessive weight is placed on an open door or if a
child climbs upon it. Serious injury might result from
spilled hot liquids or from the range itself.
Follow the instructions below to install the anti-tip
brackets.
If range is ever moved to a different location, the anti-tip
brackets must also be moved and installed with the
range. To check for proper installation, see step 5.
Tools Required:
5/16" Nutdriver or Flat Head Screwdriver
Adjustable Wrench
Electric Drill
3/16" Diameter Drill Bit
3/16" Diameter Masonry Drill Bit (if installing in
concrete)
Anti-Tip Brackets Installation Instructions
Brackets attach to the floor at the back of the range to
hold both rear leg levelers. When fastening to the floor,
be sure that screws do not penetrate electrical wiring or
plumbing. The screws provided will work in either wood
or concrete. The anti-tip brackets are attached to the
back of the range.
1. Unfold paper template and place it flat on the floor
with the back and side edges positioned exactly
where the back and sides of range will be located
when installed. (Use the diagram below to locate
brackets if template is not available.)
2. Mark on the floor the location of the 4 mounting
holes shown on the template. For easier installation,
3/16" diameter pilot holes 1/2" deep can be drilled
into the floor.
3. Remove template and place brackets on floor with
turned up flange to the front. Line up holes in
brackets with marks on floor and attach with
4 screws provided. Brackets must be secured to solid
floor. If attaching to concrete floor, first drill 3/16"
dia. pilot holes using a masonry drill bit.
4. Level range if necessary, by adjusting 4 leg levelers
with wrench. (See Figure 1 below.) A minimum
clearance of 1/8" is required between the bottom of
the range and the rear leg levelers to allow room for
the anti-tip brackets.
5. Slide range into place making sure rear legs are
trapped by ends of brackets. Range may need to
be shifted slightly to one side as it is being pushed
back to allow rear legs to align with brackets.
Remove lower panel, storage drawer or open broiler
compartment to inspect brackets. You may also
grasp the top rear edge of the range and carefully
attempt to tilt it forward to make sure range is
properly anchored.
Figure 1
Two Piece Anti-Tip Bracket
(some models)
