6
ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
5. Cabinet Installation
A. 24" and 27", Single and Double Ovens
Insert appliance into cutout. Use the screws provided to
fasten the front frame of the appliance to the cabinet.
The mounting holes in the front frame of appliance may
be used as a template to locate the appliance mounting
screw holes.
To fasten the appliance to the cabinet:
1. Line up the 2 mounting holes on the decorative trim
(ventilation) (taped to the oven side panel) with the
lower mounting holes on each side of the oven frame,
below the oven door (see figure 7).
2. Use 2 screws from the miscellaneous parts bag to
secure the decorative trim (ventilation) and appliance
to the cabinetry.
3. Use the remaining 2 screws for mounting the
appliance in the upper two mounting holes on each
side of the oven frame, above the door.
Figure 7
MOUNTING
SCREW
MOUNTING
SCREW
DECORATIVE TRIM
(VENTILATION)
Figure 8
30" SINGLE OVEN
* Recommended Cutout Width is 28 1/2" (72.4 cm)
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
29" (73.7 cm) Max.*
28 1/16" (71.3 cm) Min.
29 5/8" (75.2 cm) Max.
Mounting Brackets
22"
(55.9 cm)
21 1/4"
(54.0 cm)
Wood Shims (If Needed)
27 1/4"
(71.8 cm) Min.
28 7/8"
(73.3 cm) Max.
B. 30", Single and Double Ovens
The wall oven can tip when the door
is open. The mounting brackets supplied with the
wall oven must be attached to the cabinet and the
appliance to prevent tipping of the wall oven and
injury to persons.
Mounting Brackets Installation Instructions
1.Unpack the wall oven and find the 2 mounting screws
included in the literature package. The door may be
removed to facilitate handling (see the Owner's Guide
for instructions).
2.The mounting brackets are temporarily installed under
the decorative side trims of the oven when shipped (see
Figure 8 or 9 ). Remove the mounting brackets from the
unit side frame using a No. 2 Robertson® screw driver
(square drive preferred, however a No. 2 Phillips® or
Quadrex® screw driver can also be used). Open the door
to remove the screws, located at the upper end of the
side trim.
Figure 9
30" DOUBLE OVENS
* Recommended Cutout Width is 28 1/2" (72.4 cm)
Cutout Dimensions
28 1/2" (72.4 cm) Min.*
29" (73.7 cm) Max.*
Wood Shims (If Needed)
28 1/16" (71.3 cm) Min.
29 7/16" (74.8 cm) Max.
Mounting Brackets
42 3/4"
(108.6 cm)
42"
(106.7 cm)
49 1/8"
(124.8 cm) Min.
49 3/4"
(126.4 cm) Max.
