Frigidaire FDB2410HIB - Full Console Dishwasher, Servicing, Page: 41 / 52

Section 4 Component Teardown
4-7
Figure 4-19.
Bracket Mounting
Screws
Electrical
Connection
Water Valve
Mounting Screws
Figure 4-21.
Mounting Screws
Accessing the Water System Components
Water Valve Removal
1. Disconnect power to dishwasher.
2. Remove kickplate and outer door panel.
3. Turn off water supply to dishwasher then place
protection under water valve inlet to catch water
that will be in the line when hose is removed.
4. Extract the two screws securing valve to front cross
brace. (See Figure 4-19)
5. Disconnect wires from water valve terminals.
Terminals have locks, press down on lock to remove
terminal.
6. Remove fill hose from valve.
7. Extract the four screws securing the water valve to
the mounting bracket. (See Figure 4-19)
8. Install in reverse order.
Junction Box And Front Cross Piece Removal
1. Disconnect power to dishwasher.
2. Remove kickplate and outer door panel.
3. Extract the screw securing the junction box cover to
front cross brace. (See Figure 4-20)
4. Disconnect the wires at junction box. Extract
ground wire screw from back of junction box.
Remove the wire harness from junction box.
5. Remove water valve mounting bracket.
6. Extract the six screws securing the front cross
piece to the lower front of the cabinet.
(See Figure 4-21)
7. Complete repair in reverse order.
To access the water system components, it may be
necessary to remove the unit from its installation.
When removing the product from under the counter,
extreme care must be taken to protect the product and
the floor from damage. Always use protection under
feet and legs when pulling unit out.
The insulation wrap is removed by cutting the retaining
straps and lifting the insulation cover from the unit.
When servicing water lines, have a material available to
absorb water present in the water system. When
reinstalling, make sure unit is leveled and secured.
NOTE
Figure 4-20.
Cover Screw