Frigidaire FDB2410HIB - Full Console Dishwasher, Servicing, Page: 19 / 52

Section 2 Installation Information
2-9
Slide Dishwasher Partially Into Cabinet
1. Slide dishwasher into the opening a few inches at
a time. (See Figure 2-13)
2. As you proceed, pull the drain hose through the
opening under the sink. Stop pushing when the
dishwasher is a few inches forward of adjacent
cabinetry.
3. Make sure drain hose is not kinked under the
dishwasher and there is no interference with the
water line, wiring or any other component.
Position Dishwasher Under Countertop
1. Check to be sure that wires are secure under the
dishwasher and not pinched or in contact with door
springs or other dishwasher components.
2. Check tub insulation blanket, if equipped. It should
be positioned so it is not bunched up or interfering
with door springs. Check by opening and closing the
door.
3. Push dishwasher into cabinet. The front corners of
the dishwasher door should be flush with cabinet
doors. Be careful not to dent font panel with knees
or damage countertop or cabinets with dishwasher
components.
Level Dishwasher
1. Place level on door and rack track inside the tub as
shown to check that the dishwasher is level.
(See Figure 2-14)
2. Level the dishwasher by adjusting the four leveling
legs individually. (See Figure 2-15)
3. Pull lower rack out about halfway. Check to be sure
the rack does not roll forward or back into
dishwasher. If the rack rolls in either direction, the
dishwasher must be leveled again.
4. If door hits the tub, the dishwasher is not installed
correctly. Adjust leveling legs to align door to tub.
Turn Legs
To Adjust
Figure 2-15.
Do Not Push Against Front Door With Knee.
Damage to the Door Panel Will Occur.
Reposition Dishwasher By
Grasping Both Sides With Hands
Figure 2-13.
Check
Level
Front
To Back
Check
Level
Side
To Side
Figure 2-14.
Do Not push against front panel with knees. Damage
to front panel will occur.
CAUTION
Dishwasher must be level for proper dish rack
operation and wash performance.
IMPORTANT