Frigidaire FDB2410HIB - Full Console Dishwasher, Servicing, Page: 13 / 52

Section 2 Installation Information
2-3
Installation Preparation
1. The rough cabinet opening must be at least 24”
deep and 24” wide. The opening should be 32.5” to
35” maximum height.
2. The dishwasher must be installed so that the drain
hose is no more than 10 feet in length for proper
drainage.
3. The dishwasher must be fully enclosed on the top,
sides and back, and must not support any part of
the enclosure.
ADA installation, (32-1/2”) beneath 34” high counter-
tops may be accomplished by adjusting the kickplate
and leveling legs.
NOTE
For proper operation and appearance of unit, cabinet
opening should have dimensions as shown in Figure
2-1. If unit is to be placed in a corner, there must be
at least a 2-inch side clearance to open door.
(See Figure 2-2)
If dishwasher is installed at end of a cabinet line, sides
and back must be fully enclosed.
IMPORTANT
As a precaution, it is recommended, but not required
that the cabinets enclosing all sides of the dishwasher
(including the underside of the countertop) be sealed
with an oil based paint or moisture-proof polyurethane
to prevent possible steam/moisture damage.
NOTE
Electrical, water, and drain lines must be confined
to shaded areas in Figure 2-1. Electric conductors,
water, and drain could be damaged. Failure to follow
these instructions could result in fire or electric shock.
WARNING
Plumbing and Electrical Service
Must Enter Shaded Area
Underside of
Countertop
to Floor
32.5”
Cabinets
Square
and
Plumb
24” Max
6
24”
Min
4
Figure 2-1.
Countertop
Dishwasher
25-5/8”
Clearance for Door
Opening 2” Minimum
Figure 2-2.