Frigidaire FDB2410HIB - Full Console Dishwasher, Servicing, Page: 23 / 52

Section 2 Installation Information
2-13
Doors
Handles are secure and tight
Door seals completely to cabinet on all sides
Dishwasher door is level across the top
Leveling
Dishwasher is level, side-to-side and front-to-back
Toe grille is properly attached to dishwasher
Water and drain lines have no kinks.
Cabinet is setting solid on all corners and is
Electrical Power
House power turned on
Dishwasher is plugged in
Water System
Drain hose is assembled to drain pump
Drain functioning
Check for leaks at all joints
Final Checks
Shipping material removed
Registration card sent in
Installation Checklist
securely fastened.
Finalize Installation
Dishwasher Wet Test
1. Turn on power supply (or plug power cord into
outlet, if equipped).
2. Turn dial to Normal “Wash” position.
3. Close door.
4. Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to
be sure that water and power are turned on.
5. Check for leaks under the dishwasher. If a leak is
found, turn power supply off, then tighten
connections. Restore power after leak is corrected.
6. Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the
dishwasher if necessary.
7. The dishwasher will drain and turn off about 5 to
7 minutes after the first fill. Check drain lines.
If leaks are found, turn power off at the breaker
and correct plumbing as necessary. Restore power
after corrections are made.
8. Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
Also check drain line for kinking or obstructions.
9. Run the dishwasher through another fill and drain
cycle. Check for leaks and correct if required.
10. At the end of drain, press start cancel to turn unit
off.