Frigidaire FAFS4272L W, Tech Data Sheet

Page: 3 / 16

3
Error code chart
Error
code
Fault condition Check
E11 Fill time too long. Refer to test (1).
E13 Water leak in tub or air leak in air bell. Refer to test (2).
E21 Water not pumping out fast enough. Refer to test (3).
E25 Recirculation Pump Relay Sense Refer to Test (16)
E26 Recirculation Pump Relay Refer to Test (16)
E31 Electronic pressure switch failure. Refer to test (4).
E32 Pressure sensor calibration problem. Refer to test (4).
E35 Pressure sensor indicates water overfill. Refer to test (5).
E38 Air trap clogged. Refer to test (5).
E41 Control board thinks the door switch is open. Refer to test (6).
E43 Door PTC Circuit Problem Refer to Test (6)
E45 Line door sensing failure. Refer to test (6).
E47 Door PTC Sensing Open Refer to Test (6)
E48 Door PTC Sensing Closed Refer to Test (6)
E4A Door PTC Sensing Problem Refer to Test (6)
E52 Bad signal from tacho generator. Refer to test (7).
E53 Low Voltage to Motor Control Board. Refer to test (15).
E54 Over speed. Refer to t est (9).
E55 Under speed. Refer to test (9).
E57 High current on inverter. Refer to test (8).
E58 High current on motor phase. Refer to test (8).
E59 No tacho signal for 3 seconds. Refer to test (9).
E5A High temperature on heat sink caused by overloading. Refer to test (8).
E5C High Voltage experienced by MC. Refer to test (12).
E5D Communication problem. Refer to test (10).
E5F MC is continuously resetting. Refer to test (10).
E67 Heater sensing relay failure. Refer to test (13).
E68 Current leakage to ground on heater or fuse opened. Refer to test (13).
E71 Drum water NTC failure. (Tub heater) Refer to test (14).
E91 Communication error between UI board and main control board. Refer to test (11).
E92 UI_MB communications error Refer to test (11).
E93 Console or Main Board control problem. Refer to test (11).
E94 Main Board control problem. Refer to test (11).
E97 Console or Main Board control problem. Refer to test (11).
E98 Console control problem. Refer to test (10).
E9F Communication protocol Refer to test (10)
EA1 Power supply frequency out of limits Refer to test (12).
EA2 Power supply voltage too high Refer to test (12).
EA3 Power supply voltage too low Refer to test (12).
EA5 Main Voltage sensing failure Refer to test (12).
EAE Line safe relay sensing failure Refer to test (12).
EF1 Clogged drain pump. Unclog the drain pump.
EF2 Too much soap. Advise customer to reduce the amount
of soap they are using.
EF6 Control Reset Refer to Test (17)
EF8 Key Stuck Check all buttons