© Fresair, LLC.
Fresair.com
17 of 21
How to Install
Step 5 - Mounting the Fresair Unit
What you’ll need:
Inside the vehicle, secure the unit by attaching the mounting bracket onto each
bolt, followed by a nut.
Tighten each of the 4 nuts gradually and evenly until the sealing foam tape
compresses evenly over the roof lines or ridges.
Fresair Unit, Mounting Bracket, Finishing Frame Screws,
*Screwdriver, *Crescent Wrench(es), *Self-leveling lap sealant/Silicone
Inspect how well the foam has compressed over roof ridge lines. If there are any
gaps you need to run self leveling lap-sealant around the outside of the base and
outer edge of the sealing foam tape and onto the roof for a better weatherproof seal.
Please allow for drying time so as not to remove any of the seal.
Attach the finishing frame inside the vehicle using the two finishing frame screws
(This step can be skipped if you are building custom trim to match your vehicle’s
interior.)
NOTE
Be careful not to over tighten the bolts as this can warp or crack the base.
