995066 - Revision A
Page 33 of 41
9.12 – Leg Bearing Assembly
Within this section it will explain the correct procedure on removing and reinstalling the Leg
Bearings for servicing procedures or replacement. Images below refer to one side only, but
the instructions apply to both bearings on the product.
Removal
Step 1 - Remove the Leg Actuator Cable. (Refer to section 9.2.3)
Step 2 – Remove the Leg Actuator. (Refer to section 9.6)
Step 3 – Remove the Leg Rod Assembly. (Refer to section 9.8)
Step 4 – Remove the Front and Rear Castors. (See section 9.9 and 9.10)
Step 5 – Remove the Legs. (Refer to section 9.11)
Step 6 – Remove all four screws securing the bearing to the Frame using a 5mm Allen Key,
and slide the part out.
Refitting / Replacement
Step 9 - Refitting is a reversal of the removal process noting the following point:
A)
Ensure Loctite 243 is applied to the screws.
B)
Ensure the washers are fitted on either side as shown.
C)
Apply Silicon Grease to the bearings when fitting.
