FREEWAY S180E Mobile Hoist, User Manual

Page: 11 / 40

999367 – Revision B P a g e | 11 of 40
3.4 Electrical Connections
Connect all the cables to the control box as shown in the pictures
opposite.
A. Connect the lift actuator cable connector to the second port (marked No. 1)
from the left side of the control box (as shown in Fig. 7).
B. Connect the leg spreading actuator cable connector to the third port (marked
No. 2 in Fig. 8)
C. Connect the handset connector to the large port on the left side of the control
box. A locator pin on the plug ensures correct orientation of the connector (as
shown in Fig. 9).
D. Connect the mains cable/power cord to the control box (as shown in Fig. 10).
Ensure that all cables are located and secure before operating the Mobile
Hoist
Final Inspection
Before first operation of the Hoist:
•
Confirm all cables are located and secure.
• Ensure the red emergency stop button on the control box is deactivated. (Rotate clockwise to release if required- Refer
to section 5.4 for guidance).
• Press the up button on the handset and confirm the actuator raises the boom.
• Press the down button on the handset and confirm the actuator lowers the boom.
• Press the button on the handset to operate the opening of the legs and confirm the actuator moves the legs outwards.
• Press the button on the handset to operate the closing of the legs and confirm the actuator moves the legs inwards.
•
Press the red emergency stop button on the control box and check that actuators do not operate until the button is
reset. (See section 5.4 for guidance)
• Check the mechanical emergency lowering function works properly. (See section 5.5 for guidance)
•
Check the rear castors brakes work properly.
• Check the battery pack is fully charged.
Your Hoist is now ready to use.
Figure 7
Figure 10
Figure 9
Figure 8