User Manual
5395 Pearl Parkway, Boulder, CO 80301 | [email protected] | 866.923.6168 | www.freewave.com
FCC Notifications
FCC Supplier’s Declaration of Conformity
FreeWave Technologies, Inc.
5395 Pearl Parkway, Boulder, CO 80301
Phone Number: 303.381.9200
Website:
www.freewave.com
FreeWave Technologies declare under our sole responsibility that the product Models: FUSION-BR-WZ complies with
Part 15 of FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
The content of this guide covers FreeWave Technologies, Inc. models sold under FCC ID: KNYPMT0101AB and the
Silex WiFi/Bluetooth module solder under FCC ID: N6C-SXPCEAC2. All devices have been tested and comply under the
colocation Part 15 (b) - SDoC.
All models sold under the listed FCC ID(s) must be installed professionally and are only approved for use when installed
in devices produced by FreeWave Technologies or third party OEMs with the express written approval of FreeWave
Technologies, Inc. Changes or modifications should not be made to the device.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
FCC Part 15 Class A
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the User-Reference Manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at their own expense.
FCC NEMA Installation and Label
Where applicable, the models described in this guide must be installed in a NEMA enclosure. When any FreeWave
Technologies, Inc. module is placed inside an enclosure, a label must be placed on the outside of the enclosure. The label
must include the text: “Contains FCC ID: KNYPMT0101AB” and “Contains FCC ID: N6C-SXPCEAC2”.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 24.42cm between the radiator and your body.
FCC Notification of Power Warning
The FUSION-BR-WZ covered in this document has a maximum transmitted output power of +30dBm. The antennas used
MUST provide a separation distance of at least 24.42cm from all persons and MUST NOT be co-located or operate in
conjunction with any other antenna or transmitter.
