User Manual
5395 Pearl Parkway, Boulder, CO 80301 | [email protected] | 866.923.6168 | www.freewave.com
Hazardous Locations Installation Instructions
This equipment is suitable for use in Class I, Division 2,
Groups A, B, C and D OR non-hazardous locations only.
Open type device intended to be installed in a suitable
enclosure that requires the use of a tool to access.
Ambient: -20°C to +70°C
Temperature Code: T4
Input voltage rating of +6 to +30 VDC, 14W
WARNING – EXPLOSION HAZARD. DO NOT CONNECT
OR DISCONNECT WHEN ENERGIZED. AVERTISSEMENT
– RISQUE D’EXPLOSION. NE PAS BRANCHER NI
DÉBRANCHER SOUS TENSION. WARNING – EXTERNAL
USE OF THE ANTENNA IS NOT PERMITTED. THE
ANTENNA IS TO BE TERMINATED AND MOUNTED
INTERNAL TO THE FINAL INSTALLED ENCLOSURE
AVERTISSEMENT - L’UTILISATION EXTERNE DE
L’ANTENNE N’EST PAS AUTORISÉE. L’ANTENNE DOIT
ÊTRE TERMINÉE ET MONTÉE À L’INTÉRIEUR DU BOÎTIER
FINAL INSTALLÉ
The Antenna must be a 50OHM, passive type.
Note on Nominal Gain Antennas (2.3dBi): When using
nominal gain antennas (ex. MobileMark 2.3dBi, default
for the product) connected to the stock faceplate of the
Fusion device. The device must be at least 34cm away
from other transmitter antennas from other devices in order
to eliminate the possibility of any colocation interference
from the two transmitters. Failure to accommodate this
requirement will result in non-compliance and/or create
a situation where interference from the antennas creates
a non-compliant noise environment, causing degraded
performance from RF devices.
Note on High Gain Antennas (6dBi): When using high
gain (6dBi) antennas with the Fusion device for either
the 900MHz or the WiFi radio, the antennas need to be
spaced no closer than 34cm from each other, in order to
maintain FCC compliance and not create interference that
may degrade radio performance. When utilizing high-gain
antennas, it is recommended that the user not mount the
antennas directly to the Fusion device front faceplate, but
rather mount the antennas to an external mount point and
connect the antennas to the device using coax cable (certain
lengths available from FreeWave upon purchase).
Power Output listed is conducted. Single Modular Approval.
This device is granted for use in Mobile only configurations
in which the antenna(s) used for this transmitter must
be installed to provide a separation distance of at least
24.42 cm from all persons and not be co-located with any
other transmitters except in accordance with FCC multi-
transmitter product procedures. End-users and installers
must be provided with antenna installation instructions and
transmitter operating conditions for satisfying RF exposure
compliance.
The Grantee is responsible for providing the documentation
required for modular use. The responsibility for the use of
this module, in all configurations utilized or contemplated,
remains with the Grantee.
Battery Note: This device houses a lithium polymer coin
cell battery that serves to maintain certain functions of the
device. It is not intended to be replaced by the user and
should only be handled and/or replaced by a certified or
instructed technician.
Warning - Export Compliance: This document describes a
product that contains encryption and is subject to the Export
Administration Regulations (EAR) and Office of Foreign
Assets Control (OFAC). This product may be restricted
to certain countries and users. Access to this document
does not guarantee or imply the product will be available
for purchase to a specific end-user. Export, re-export,
release or transfer of the product in violation of U.S. Export
Regulations including the International in Traffic Regulations
(ITAR), Export Administration Regulations (EAR) or Office
of Foreign Assets Control (OFAC) is prohibited. Any party
exporting, re-exporting, releasing or transferring the product
is responsible for obtaining all necessary U.S. government
authorizations as required to ensure compliance with
these and other applicable U.S. laws. Consult with your
Trade Compliance department or legal counsel for further
guidance or contact [email protected]. Violations
of these regulations are punishable by fine, imprisonment, or
both. Diversion or use contrary to U.S. law is prohibited.
