5 Removing the enclosure
To change switch or jumper settings, you need to open the board chassis. The steps to open the board chassis are:
1. Remove both screws from the top side of the chassis, as shown in the figure below.
Figure 3. Removing screws from top side of chassis
2. Remove both screws from the back side of the chassis, as shown in the figure below.
Figure 4. Removing screws from back side of chassis
3. Remove the top cover carefully.
Removing the enclosure
T4240RDB Quick Start Guide, Rev 0, 11/2013
Freescale Semiconductor, Inc.
5
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
