FREERIDER X2 HUB, Manual, Page: 14 / 20

WARNING - Risk of falling!
Please note the following points to minimise the risk of falling:
1. Before you go, always open the sidebar.
2. Hold the steering wheel straight.
3. When turning, starting in a curve or when driving in a narrow curve the brake Easy to operate. This
interrupts the electric drive force and safe driving without driving influences.
During the trip:
If there are any unusual noises or problems, stop the journey and inform the manufacturer. Service
addresses can be found in the operating manual.
The electric scooter is equipped with front and rear disc brakes, which are operated by the hand brake
handle on the steering wheel. The scooter is equipped with a regulator which interrupts the power supply
to the engine in the short term when the brake lever is pressed.
Attention
The front brake can react very directly.
Practice braking on a flat and dry surface to familiarize yourself with the braking system. The brake path
depends on the driver's weight, weather and surface.
A quiet of the brakes is nothing to worry about. The brake lining should then be applied slightly. In the case
of hard -quality brake linings, a Qietsch can occur frequently. For soft coatings less rare, but therefore
increased wear.
10. Starting and driving
11. Brakes
12. Tyres and wheels
13
The scooter has identical front and rear tyres. Only tyres approved by the manufacturer may be used
when changing tyres.
Other tyres lead to a loss of road clearance.
Attention
In case of disregard, the operating licence expires.
Tyre:
It is recommended to pump the tyres to air pressure of 3.5 in cash.
You can do this at any gas station. These are standard car valves.