8.6. Maintenance and instructions for charging the batteries
NOTE
Failure to comply with the instructions may result in the battery being discharged. No warranty can be
accepted for low -charged batteries. Therefore, in order to achieve the longest possible life of the battery,
it is imperative that the following information be taken into account:
-The charger shall not be activated in a battery temperature range below +10 and over +60 degrees.
Therefore, bring the battery to room temperature before each charge.
-Choose a storage place where the FREERIDE X2 HUB is stored as far as possible at room temperature.
-Reload the battery after use, irrespective of the previous route or the energy taken.
-The charger is an intelligent system with monitoring and control functions.
-After the charging process is completed, the charger must be disconnected from the battery and must
not be left at the disconnected charger.
-Battery in case of prolonged non -use by no means permanently on the charger leave connected.Keep
the vehicle in a dry room at room temperature when it is closed (e.g. in winter).
-Always recharge your battery every three months at the latest.
-When the vehicle is restarted after a longer service life (e.g. after a winter break), the battery should be
connected to the charger for a complete charging.
-Duration of charge: The battery is fully charged with the supplied charger with 2.0 A charging power in
approximately eight hours.
-The battery should be fully charged before first use.
-Never let the batteries completely discharge.
Use only original FREERIDE X2 HUB approved batteries to prevent damage to the controller. The use of
unauthorised batteries results in the loss of the warranty.
The maximum achievable range with a charge of the battery depends on a number of factors. These
include the battery and charging condition, temperature conditions, route profile and driver weight as well
as the corresponding driving mode (e.g. stop -go, full load, mountain valley, etc.).
WARNING
In case of disturbances check:
-Is the power cable properly connected?
-Are the contacts of the charger and the battery clean, not damaged or bent?
-Is the battery damaged or defective?
-Is the charger plug stuck in the battery box?
If a proper charge of the battery is not possible, please have the battery and charger checked by a
specialist workshop.
11
Summary of Contents for X2 HUB
Page 20: ...FREERIDE HUB Manual ...