10
Warning:
If the installed Luggie battery has been idle for a long period, the
battery may be in a low power state.
Warning:
The best practice is to remove the battery when transporting the
scooter so as not to accidently power on the scooter which cause injuries and drain
the battery.
Warning:
Armrest Installation (optional): If your purchase comes with armrests, refer
to the Luggie Armrest Installation Guide included with your scooter order. Insert and screw
the adjustment knobs on the bottom side of the back of the seat assembly.
Note: The knobs do not need to be screwed on too tightly. These knobs are pull-pin knobs
for you to adjust the width of the armrests.
Caution:
The backrest of your seat will not fully fold forwards if the armrests are
positioned too closely towards one another.
Warning:
When the scooter is in operation, the armrests should not be in the
raised position.
TILLER ADJUSTMENTS
The controls of your scooter are located on the top console in front of the handlebars when
seated on the Luggie.
1.
2.
The tiller of your Luggie is designed to allow you to position the handlebars in
a comfortable driving position. It can be locked into numerous positions for your
comfort and ease of transport.
To adjust the angle of the tiller (angle the handlebars), locate the trigger as
pictured in (FIG 6). Pull the black lever (trigger), outward to adjust the angle of the
tiller. To lock the tiller in your desired position, simply release the trigger or the
black lever.
1.
Status Light:
The power switch on your Luggie doubles as the status light indicator.
When the Luggie is powered 'on', the light on the switch will be illuminated as
a solid for the entire duration of the 'on' state. When your battery run low in power,
the status light will flash slowly at one flash per second. This is the scooter’s way
of telling you that it is low in fuel and a charge is needed. If you notice the
status light flashing at two flashes per second, you are being notified that the
battery voltage is too low to drive. You must stop using your scooter at the earliest
opportunity when this happens. There is a total of nine status light flashing diagnostic
signals for the Luggie, refer to "Basic Fault Finding" section in the rear of this
manual for reference.
2.
Battery Indicator:
The battery indicator is located on the top console between the
handlebars. When your scooter is switched on, the indicator on the gauge will
move across the scale from the left 'red' sector towards the 'green' sector, indicating
the state of charge of your battery. As the power is used up the indicator will move
towards the red sector indicating the state of charge at that precise time. When the
indicator is fully over to the right (green sector), the battery is fully charged. When
the indicator falls in the red sector your battery is low in charge and need to be re-
charged. Refer to the battery and battery charging section for further details.
