37
STATUS FAULT CODES
FLASH
Description
Meaning
1
Battery Low
The batteries are running low.
Recharge the batteries.
2
Low Battery Fault
The batteries have run out of charge.
Recharge the batteries.
Check the battery and associated connections
and wiring.
3
High Battery Fault
Battery voltage is too high. This may occur if
overcharged &/or travelling down a long slope.
If travelling down a slope, reduce your speed
to minimize the amount of regenerative
charging.
4
Current Limit Time-out
The motor has been exceeding its maximum
current rating for too long.
The scooter may have stalled. Turn the
controller off, leave for a few minutes and turn
back on again.
The motor may be faulty. Check the motor and
associated connections and wiring.
5
Park Brake Fault
Either a park brake release switch is active or
the park brake is faulty.
Check the park brake and associated
connections and wiring.
Ensure any associated switches are in their
correct positions.
6
Throttle OONAPU
Either a Stop function is active or a Charger
Inhibit or OONAPU condition has occurred.
Release the Stop condition (seat raised etc.)
Disconnect the Battery Charger
Ensure the throttle is in neutral when turning
the controller on.
The Throttle may require re-calibration.
7
Speed Pot Fault
The throttle, speed limit pot, SRW or their
associated wiring may be faulty.
Check the throttle and speed pot and
associated connections and wiring.
8
Motor Voltage Fault
The motor or its associated wiring is faulty.
Check the motor and associated connections
and wiring.
9
Other error
The controller may have an internal fault.
Check all connections and wiring.
