35
Q: What if my Luggie will not start?
A:
Check to see whether the power switch has been switched ‘on’. If it is, the battery
indicator meter will be operating. If the status light on your top console is flashing once per
second, your battery is low in charge. Charge your battery.
Q: What if the status light on the power switch fail to operate when the switch is in
the 'on' position?
A:
Make sure the charger is not plugged into the charge socket of your scooter. When your
scooter being charged, you will not be able to drive.
Q: What if my Luggie stops for no apparent reason?
A:
Your battery may not be working properly. Contact your Authorized Luggie Reseller.
Q: What if the battery indicator is operational but the status light flashes and the
Luggie is inoperable?
A1:
Check the status fault codes (page 37-38) indicated by the LED on your power switch
flashing.
A2:
Check to make sure that the magnetic brake release is not disengaged. If the magnetic
break release is disengaged, the status light on the power switch will flash five times.
Q: What if my Luggie does not slow down or behave erratically?
A:
Switch off the power and contact your Authorized Luggie Dealer.
Warning:
If you find for any reason your Luggie does not reduce speed when you let go
of the wig-wag lever, power off your Luggie. The parking brake will activate immediately
and stop your scooter. Be aware that the scooter will stop very suddenly. Hold onto your
handlebars and sit back in your seat.
Warning:
The above operation should only be carried out in an emergency; continual
use of this facility will damage the drive transmission and motor brake. Inform your
Authorized Dealer before using your scooter again.
Warning:
If you feel for any reason that your scooter is not driving correctly or making
unusual noise, stop using the scooter and contact your Authorized Dealer.
SPEED CONTROL
The speed controller system incorporates a sophisticated microprocessor which continually
monitors the Luggie scooter's systems to ensure safe and reliable operation. Safety
conditions monitored by the speed control are listed below:
Speed control system integrity
Internal voltages and circuits
Motor voltages and circuits
Freewheel speed limiting downhill
Battery voltage
BASIC FAULT FINDING
