BASIC FAULT FINDING
If your Scooter will not start:
1. Check the power key switch is turned 'on'. If it is, the
battery condition indicator meter will be operating. If the
green status light on your console is flashing once per
second, charge your batteries.
If the battery condition meter and the green status light fail
to operate when the key switch is in the 'on' position, check
the following:
1. Make sure the battery charger is not plugged into the
tiller charge socket, this will prevent drive.
2. Check both battery connectors.
Check battery terminal condition.
3. Check the 'circuit breaker' (Fig 36): If your Scooter
stops for no apparent reason, it is probably due to the
circuit breaker disconnecting from the speed control
lectronic box.
On rare occasions, a temporary overload on the electric
circuit can occur - for instance when climbing a steep
incline. If this happens, the circuit breaker, which is located
under your Scooter's rear cover and beneath your seat
will trip and pop out. To reset the circuit breaker wait for
two minutes to allow the temperature activated switch to
cool down. Locate the plunger on the circuit breaker
through the access hole (Fig 36 ). Place a finger onto the
circuit breaker and press down on the plunger until it
remains down. You are now ready to drive again.
If the circuit breaker trips up again wait for 5 minutes and
try again.
If you find the circuit breaker is continually tripping
out, contact your authorised dealer.
The battery condition indicator meter operates and the
green status light flashes, your Scooter does not drive:
Check the 'white' plug's, located under the rear cover
and positioned in the main controller module (see Fig 25
page 20). Check also the status fault codes (page 32 )
indicated by the green L.E.D. on your console flashing.
If your Scooter does not slow down or behaves erratically:
1. Turn off the power 'on' key switch.
2. Inform your authorised dealer.
If you find for any reason your Scooter does not
reduce speed when you let go of the forward-reverse speed
lever . Switch your Scooter 'off' with the on/off key.
The parking brake will activate immediately and stop your
Scooter. Beware the scooter will stop very suddenly, brace
yourself with the handlebars, sit back in your seat.
Caution:
Warning:
Caution:
Warning:
FIG 36
This operation should only be carried out in an
emergency; continual use of this facility will damage the drive
transmission and motor brake.
The speed controller system incorporates a sophisticated
micro-processor design (Fig 37). It is located under the rear
cover of your Scooter. The in-built micro-controller
continually monitors the Scooter's systems to ensure safe and
reliable operation.
Speed control system integrity
Internal voltages and circuits
Motor voltages and circuits
Freewheel speed limiting downhill.
Battery voltage
When the battery voltage is low, the 'status' indicator light
situated on the control console (a green light positioned next
to the battery state indicator meter (Fig 10 page 10) will flash
Warning:
Inform your authorised dealer before using your machine again.
Warning: If you feel for any reason that your Scooter is not
driving correctly or making an unusual noise, stop using the
machine. Be safe, contact your dealer, he will be able to
advise you.
IMPORTANT SPEED CONTROLLER INFORMATION
GENERAL DESCRIPTION
SAFETY CONDITIONS MONITORED INCLUDE
Warning:
Warning:
IMPORTANT SPEED CONTROLLER INFORMATION
GENERAL DESCRIPTION
FIG 37
30