27
5.
Remove the Idler Roller (76), the Drive Roller (55),
the Walking Platform (52), and the Walking Belt (53).
Check to see whether both sides of the Walking
Platform (52) are worn. If the bottom side is not
worn, you can turn over the Walking Platform and
continue using it. If the Walking Platform has been
turned over previously, discard the old Walking
Platform.
Save all other parts.
Using the new Walking Platform (52) or the old
Walking Platform with the unworn side facing up,
follow steps 1–5 in reverse order.
6.
Lift the right or left edge of the Walking Belt (53) and
look for a small arrow printed on the underside of
the Walking Belt; move the Walking Belt, if neces-
sary, as you look for an arrow.
If you fi nd an arrow,
make sure that the arrow is pointing toward the
rear of the treadmill, as shown.
If it is not, remove
the Walking Belt, turn it around, and slide it back
onto the Walking Platform (52). Note: Your walking
belt may not have an arrow. If it does not have an
arrow, it can be turned either way.
Next, move the Walking Belt (53), if necessary, until
the seam (not shown) across the Walking Belt is
beneath the Walking Platform (52). Next, carefully
follow steps 1–4 in reverse order.
Then, locate the indicated marks on both sides of
the Walking Belt (53). The marks should be exactly
36 in. (91.4 cm) apart.
See the drawing in step 7
on page 28.
If necessary, turn both M10 x 80mm
Screws (28) counterclockwise until the marks are
exactly 36 in. (91.4 cm) apart.
5
53
52
55
76
6
53
Arrow
52
36 in.
(91.4 cm)