34
b.
If the walking belt has shifted to the left:
Remove the key and unplug the power cord.
Using a 7/32" hex key, turn the roller adjustment
screws in the directions shown, 1/4 of a turn each.
Be careful not to overtighten the walking belt. Then,
plug in the power cord, insert the key, and walk on
the incline trainer for a few minutes. Repeat until
the walking belt is centered between the foot rails.
c.
If the walking belt slips when walked on, first
remove the key and
UNPLUG THE POWER
CORD.
Using a 7/32" hex key, turn both roller
adjustment screws clockwise, 1/4 of a turn. To
properly tighten the walking belt, see step 7 on
page 31. Be careful to keep the walking belt cen-
tered. Then, plug in the power cord, insert the key,
and walk on the incline trainer for a few minutes.
Repeat until the walking belt is properly tightened.
SYMPTOM: The walking belt stops or the incline
cannot be adjusted even though the console
remains lit
a.
This indicates that a controller error may have
occurred. To correct the problem, turn the power
switch off, wait 5 seconds, and then turn the power
switch back on.
b.
This may be a symptom of high amp draw. Lubri-
cate the walking belt if necessary (see page 31).
SYMPTOM: The incline system does not function
properly or the incline system does not appear to
be at the incline level shown in the display
a. Calibrate the incline system (see THE
MAINTENANCE MODE on page 26).
b.
If the incline system still does not function properly,
please see the back cover of this manual.
Left
b
c
