15
15.
Make sure that all parts are properly tightened before you use the incline trainer.
To protect the floor or
carpet, place a mat beneath the incline trainer.
If you purchased the optional MYE receiver to set up a wall of TVs, follow the step below to install the
MYE receiver. To order the MYE receiver, see the back cover of this manual.
16. Remove the four #8 x 1/2" Screws (66), and then
remove the Console Access Cover (92).
Next, plug the cable (I) from the console assem-
bly (F) into the “In” port on the receiver (J).
Next, peel the backing (K) off the receiver (J),
and press the receiver onto the Console Access
Cover (92) in the location shown by the dashed
line.
Then, reattach the Console Access Cover (92)
with the four #8 x 1/2" Screws (66).
Follow the instructions included with the
MYE programmer to program the receiver
(J).
IMPORTANT: After the receiver is pro-
grammed, you will need to turn off power to
the incline trainer and then turn it back on.
See page 17 to plug in the power cord. See
page 20 to turn on the power.
66
66
I
K
92
F
J
16
14. Attach the Left Upright Cover (151) to the Left
Upright (149) with three #8 x 3/4" Screws (16);
start all three Screws, and then tighten them.
Do not overtighten the Screws.
Attach the Right Upright Cover (not shown)
to the Right Upright (not shown) as described
above.
After the incline trainer is placed in the location
where it will be used (see HOW TO MOVE THE
INCLINE TRAINER on page 16), make sure that
both Leveling Feet (38) rest firmly on the floor. If
the incline trainer rocks even slightly, loosen the
nut on a Leveling Foot, turn the Leveling Foot
clockwise or counterclockwise until the rocking
motion is eliminated, and then tighten the nut.
16
151
149
38
16
14
